INSTRUCTION MANUALThis Infant Seat is for useby children who meet BOTH of the requirements below: Weight is: 4 to 22 pounds (1,8 to 10 kg)Height is:
Section 6 - Selecting AVehicle Seating Location • Use only in a rear facing position when using this restraint in a vehicle. • DO NOT use this inf
10 Use Of Via I440 Infant Seat Child Restraint In Conjunction With Side AirbagsTo determine the typ
Section 6 - Selecting AVehicle Seating Location 3. V ehicle Seats: DO NOT use this Infant Seat with the following vehicle seats: Seats Which Face Si
12 Section 6 - Selecting AVehicle Seating Location 5.Vehicle Seat Belt Systems:Use only the vehicle’s lap and shoulderbelt, lap belt or LATCH system
Section 6 - Selecting AVehicle Seating Location LAP BELTSManually-adjusted lap beltThis type of lap belt is tightened by pulling on the excess belt o
Section 6 - Selecting AVehicle Seating Location 14Lap and Shoulder Belt with Dual RetractorsDo Not Use!- Each autobelt Strap hasa retractor at each en
• Use only with children who weigh between 4 and 22 pounds (1,8 and 10 kg) or less and whose height is 30 inches (76 cm) or less. • • •
Section 7 - Installation and Use 1 2- Leveling base. . Level Vehicle -- Place seat in base and check level indicator to see if base
Section 7 - Installation and Use2- Press down on base with knee, tighten auto belt and insert buckle tongue into buckle. Close and se
Section 7 - Installation and Use2- Press down on base with knee, tighten auto belt and insert buckle tongue into buckle. Close and se
Dear Parents, Thank you for purchasing The First Years Via I440. We hope that it will make your baby’s travel safer, easier, and more pleasant. We
Section 7 - Installation and Use 12 - Remove BOTH LATCH Lower Anchor connectorc from the LATCH Lower Anchor storage compartment. 3-
Section 7 - Installation and Use 12 - A locking clip may be purchased by calling Learning Curve 1-888-899-2229.3- Follow the base installat
Section 7 - Installation and Use 1- 2 - Lower Infant seat on to the base. 3- NOTE-You should hear a positive click when the Infant
Section 7 - Installation and Use 12 - Base installed with Lap and Shoulder belt.3- Base installed with LATCH connectors and LATCH Bar
Section 7 - Installation and Use 23 - Infant Seat and base installed with LATCH connectors to LATCH bars. . Infant Seat and Base installe
Section 7 - Installation and Use 1 2- Check That Handle is Locked . Positioning of Handle--- Before the Infant seat is lifted for any reason, check
Section 7 - Installation and Use 1- 2- Grip red handle and gently pullup. Pull straight up on the I440 by the handle and the front o
Section 7 - Installation and Use 1- A Chest Clip- To Unlock - Squeeze center locking tabs - Pull Chest clip apart 2 - To Lock -
Section 7 - Installation and Use 3- B 5 Point Buckle- To UnLock - Press red center button until the 5 Point Buckle releases. - Pull Buc
Section 7 - Installation and Use 5- . C Harness Adjuster To loosen harness system - The Harness Adjuster is locatedat the Lower end of the In
2 Section 2 - Table Of Contents Section 1 Introduction ... 1 Section 2 Table Of Contents...
Section 7 - Installation and Use 7- To Raise or Lower Harness . D Shoulder Height Adjustment -- Pull out the yellow adjustment knob located o
Section 7 - Installation and Use 12- Rotation . InstallationTo install Canopy-- The canopy has a full rotation. Push or pull to raise or lower
Section 7 - Installation and Use 1-Babies with Low Birth Weight 7.13 Positioning/Removal -- Rolled towels can be added for side support for smal
Section 7 - Installation and Use 4 1-Unfasten outer snaps, remove canopy, head bols
Section 7 - Installation and Use 1. Lower dry pad on shell allowing the attachment flaps to remain open.2. Pull harness through open flaps
Section 8 - Safety Checklist/Safe Practices For assistance with installation or use, contact one of the following sources: - Learning Curve at: Phone
Section 8 - Safety Checklist/Safe Practices √ Did you read and understand these instructions and labels on the Infant Seat? √ Is the child the prop
Section 9 - Additional Information Certification: This child restraint system conforms to all applicable Federal Motor Vehicle Safety Standards for us
Section 10 - Care and Cleaning Removing Seat Pad: - Gently unsnap metal snaps after following the directionson page 32. . Cleaning Seat Pad, Head Bols
Blank Page
Section 2 - Table Of Contents Section 9 Additional Information...36Section 8 Safety Checklist/Safe Practices...34Se
Keep this instruction manual for future use. Store in pocket on bottom of the Infant Seat. © 2008 Learning Curve Brands 4000000609
• Failure to follow these instructions and Infant Seat labels can result in injury or death to a child from striking the vehicle’s interior during a
4 • Direct sunlight can make Infant Seat surfaces hot enough to burn your child. Use caution and check the vehicle and Infant Seat on hot, sunny day
• W ARNING DEATH or SERIOUS INJURY can occur 6 Section 4 - Use Recommendations The First Years advises parents that children should use a childrestra
7 Section 5 - Infant Seat Parts Harness Adjuster Aluminum Handle Head Bolster 5 Point Harness Full Rotation Canopy Instruction Storage Harness Ret
8 Section 5 - Infant Seat Parts L.A.T.C.H. (2) Steel Retention Hooks Base Height Adjust Angle Indicator Auto Belt Lock Off The Infant Seat must be
Comments to this Manuals